Under development on the SW52 and SW32 rifle:

The proposed design will be as follows:

Hk93 style receiver

Hk 91 bolt head and firing pin

Hk 91 shortened bolt carrier

New trunion

Hk91 trigger housing parts

Mp5 stock

mp5 handguard on 52

Hk 33 handguard on the 32

8" barrel on 52 with fake hider/comp

16" barrel on 32 with fake hider

uses AK mags unmodified

paddle AK mag release

factory front and rear sites

Will take claw mount and all Hk accessories including tele stock but illegal without sear

here is a real Hk 32K very similar

this gun will accept standard Hk sears!!!!

est price will be $775 retail

Dealer $650

we will offer very large discounts for large gun buys of 25 to 100 units

I have 3000 parts I need to get rid out of my shop and this project my just do it!!!

Schedule

first shooting gun in feb 2003

orders in March 2003

production May 2003-March 2004 at this price should be out by then

Flash light system in molded into the receiver as well as the mount for the laser, the scope rail is also molded directly into the receiver.

The side folding stock has a removable rubber end to extend the length of the stock up to 1.5 inches, the gun accepts standard Hk Mp5K trigger groups.

The rear of the receiver is the same as the MP5k while the front is the same as an Mp5.

Most of the factory Mp5 parts will work in this weapons the recoil and locking pieces options will be increased to allow for maximum recoil reduction with different loads. This will NOT be made in a semi auto version, all receivers will be forward push pin style only for PD sales only.

Update pics 12-16-02

The rubber on the end of the stock is removable so the length can be extended up to 1.5"

The gun uses standard mp5 mags and has both a ambi paddle mag release and a left side release also, notice the access hole in the flashlight mount for on off switch and insert molded studs in the top cocking tube for sling attachment locations

The stock has 3 sling mounting locations for all possible conditions, the stock hinge is very small due to the fact it is steal not plastic, insert molded steal fittings.

The rear cap is not shown but the stock closes to cover it up it will have a sling point on the cap so the gun can be carried in a shoulder rig.

The side folding stock is hollowed out in the rear to decrease weight

The final changes are done we are going to molding Jan 1, 2003 molds should be done in 90 days!!!!

We will post pics of the first guns when we run the molds

Like with all our products, others talk, we deliver!!!!